Author Topic: K1300S 2011 Front ESA Shock  (Read 6882 times)

mjhts2018

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
K1300S 2011 Front ESA Shock
« on: February 22, 2018, 09:38:00 AM »
Hi All

New to this so please be nice  :-[ Just to put you in the picture, I have a 2011 K1300S with 65k miles on clock where I am, with the aid of my friend (who is a mechanic) are going to replace the dreaded upper and lower from suspension ball joints as on last MOT (i'm in UK) noted about the ball joint play. Whilst going to start we also noted a leak from my front shock  :o so I have found a company in UK (firefox racing) who will do a complete strip and rebuild as BMW want £900 just for the shock!!

My question is, guy at BMW said the shock may need a calibration on their computer after refitting, however guy at firefox said it shouldn't as its the same one going back in....

I don't have a GS-911, but i'm not opposed to buying one, but can anyone please tell me if this procedure needs to be done?? Also has anyone done their ball joints before?

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
Re: K1300S 2011 Front ESA Shock
« Reply #1 on: February 22, 2018, 08:48:46 PM »
The GS-911 has a function to calibrate the ESA. Note this is not the same as coding a unit to a bike (not sure if coding would be needed on an ESA shock anyway).

The ball joints do seem to be a common wear point on the K4x models.

If you are a member of the BMW Club UK then they have a tool Hire facility, which has a number of special tools to assist when chhanging the ball joints (there are some serious torque settings - 260Nm). One tool is a special spindle used in place of the original wheel spindle, which is used to enable the assemly to be held securely in a vice.

The Club also has GS-911 diagnostic tools and BMW workshop manuals.

Mike


mjhts2018

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: K1300S 2011 Front ESA Shock
« Reply #2 on: February 22, 2018, 09:03:23 PM »
Thanks Kindly Mike, much appreciated. I will print this and take to my friend. I am not a member but will now join. Not looking forward to these couple of jobs but nice to have advice on hand and i'm sure we can successfully strip and rebuild!

Matt

panason1c

  • Newbie
  • *
  • Posts: 20
  • Karma: +1/-0
Re: K1300S 2011 Front ESA Shock
« Reply #3 on: February 25, 2018, 10:50:28 AM »
The GS911 can only calibrate the rear s/a and NOT the front s/a on the K1300S. (Unlike some of the GS models)
I replaced the front s/a on my K1300s with a used one from another K1300s and it didnt need calibrating, I ran the suspension settings from comfort through to sport and all was good.

mjhts2018

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: K1300S 2011 Front ESA Shock
« Reply #4 on: February 25, 2018, 09:34:53 PM »
Very much appreciated guys  8) :D