General Category > How do I...

Updated but now won't open

<< < (2/3) > >>

WayneC:
The WiFi web interface is independent of any app on the PC so where the GS911 has been configured into your WiFi network you should be able to connect to it by keying in the IP No

The WiFi pC utility is not updated or changed during a GS911 WiFi firmware update so I can only assume it is your PC which is reporting unable to open the App, a screen shot would be helpful

It is possible that the GS911 WiFi App now needs updating to match the new firmware but I would only expect that to be the case if the GS911 WiFi and PC WiFi App were quite old from the day you purchased it

manic mechanic:
OK, just tried again.  The WiFi interface is seen by the wifi utility via USB.  The yellow interface, when using the GS-911 application, gives an error message of "Failed to load file, application will close."

WayneC:
What IP No is showing for the GS911 ?

Connect to the GS911 WiFi interface with the browser and confirm the version numbers etc, post the info here, you will find it all in "about"

Also check for update, and that will confirm the firmware update completed properly, if the GS911 was depowered prior to an update being completed it will then attempt to complete it the next time it is powered up. It can take up to 1/2 hour to complete

manic mechanic:
I'm contemplating deleting then reloading the GS-911 app to see if that may clear things up.

manic mechanic:
For the wifi, IP is 10.0.0.1

Navigation

[0] Message Index

[#] Next page

[*] Previous page